Window Belt Mouldings - Poor Fit
NO: 23-34-95 Rev. AGROUP:Body
DATE: Sept. 22, 1995
SUBJECT:
Window Belt Moldings
Poor Fit, Warp and/or
Delaminate
THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 23-34-95 DATED JUN. 9, 1995 WHICH SHOULD BE REMOVED FROM YOUR FILES. SYMPTOMS AND PARTS HAVE CHANGED. ALL REVISIONS ARE MARKED WITH **ASTERISKS**
MODELS:
1995 (JA) Cirrus/Stratus
SYMPTOM/CONDITION:
**Window belt moldings may fit poorly in the rear door flag area or warp and/or delaminate.**
PARTS REQUIRED:
1 **4874110 Package, Window Belt Molding**
Contains: 1 **4630790 Belt Molding, RR Window**
1 **4630791 Belt Molding, LR Window**
1 **4630792 Belt Molding, RF Window**
1 **4630793 Belt Molding, LF Window**
4 6000258 Barrel Clip, Rear Door Belt Molding
1 K6853313 Instruction Sheet
AR 82300068 Mopar Corrosion Inhibitor (One Can Will Do 25-50 Vehicles)
REPAIR PROCEDURE:
This bulletin involves replacing all four widow belt moldings with revised parts.
NOTE:
IF ONE BELT MOLDING REQUIRES REPLACEMENT, THEN ALL FOUR BELT MOLDINGS MUST BE REPLACED WHICH HAVE NOT HAD THE CURRENT PART NUMBERS INSTALLED (4630790,91,92,93)
1. Lower door glass for the following procedure.
2. Remove the single attaching screw (at the rear of the front doors, and front of the rear doors) securing one end of each molding.
3. Pull upward on the screw end of the molding and separate from vehicle. The front window moldings must be pulled rearward from under the mirror. The rear window moldings must be pried outward at the flag area to disengage the flag retainers.
4. The center molding attaching clips will scratch paint off the door sheet metal as they are removed. To prevent corrosion, coat the scratches liberally with Mopar Corrosion Inhibitor, P/N 82300068, just prior to installing the new moldings.
5. Install the front window moldings by inserting the forward end under the mirror and work into position from front to rear using the heal of your hand. Install attaching screws.
6. Remove existing barrel clips from the rear door flag area and install new clips, P/N 6000258.
**NOTE:
USE MASKING TAPE OR OTHER SUITABLE MATERIAL TO PREVENT SCRATCHING "B" PILLAR APPLIQUES AND GLASS RUNS DURING INSTALLATION OF WINDOW BELT MOLDINGS.**
7. Install rear window molding by placing radius of flag area over door flange. Push and seat molding flag posts into clips on door. Work molding into place with heal of hand, starting in radius of flag and then two center clips. Check that flag is seated fully into clips. Install attaching screws.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No: 23-02-13-94 Install All Four Moldings 0.4 Hrs.
FAILURE CODE: P8 - New Part