Control Module HVAC: Service and Repair

Fig 29 Control Module:

NOTE: The control module is located below the radio.

REMOVAL
1. Place the ignition key in the OFF position before removing control module.
2. Remove trim bezel.

Fig 30 Control Module Screws:

3. Remove cluster hood bezel retaining screws in the trim bezel opening.
4. Pry up the cluster hood bezel a few inches to expose the cubby bin/cigar lighter bezel screws.
5. Remove the cubby bin/cigar lighter bezel and wiring.
6. Remove the control module retaining screws.

Fig 31 Control Module At Bezel Opening:

7. Drop the A/C control module into the cigar lighter/cubby bin bezel opening. Then disconnect the wiring on the rear of the control module.
8. Release the cable clips from the top of the control module. Retain the clips for future use. Then disconnect the temperature control and recirculation control cables.
9. Remove the control module.

INSTALLATION
For installation reverse the above procedures. Verify that the cables are properly adjusted and the module is seated properly.