Front

REMOVAL
1. Remove half of brake fluid from reservoir.
2. Raise and support front of vehicle.
3. Remove wheel and tire assembly.
4. Remove caliper guide pin bolts, then wedge caliper away from rotor using a screwdriver to break gasket adhesive seals.
5. Remove caliper by slowly sliding assembly out and away from rotor.

NOTE: Suspend caliper with wire to avoid damaging brake hose.

6. Remove outboard pad, then the inboard pad by sliding off of adapter.

INSTALLATION
1. Lubricate adapter ways with suitable grease.
2. Install inboard pad, then the outboard pad onto adapter.
3. Lower caliper over rotor and pad assemblies, then install guide pins. Tighten pins to specifications.
4. Install tire and wheel assembly, then lower vehicle.