Operation CHARM: Car repair manuals for everyone.
Home >> Chrysler >> 1996 >> Concorde V6-201 3.3L >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Impact Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Impact Sensor: Service and Repair

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Remove two headlamp pins and remove headlamp.
3. Remove four headlamp carrier fasteners and remove headlamp carrier.




4. Remove three screws holding sensor to headlamp carrier surface and remove sensor.
5. Disconnect impact sensor electrical connector.

INSTALLATION
1. Connect sensor wiring lead from harness to connector on body of sensor.




2. Install left sensor (arrow pointed forward as shown) to headlamp carrier surface, using three screws provided with new sensor and tighten to 3 to 5 N.m (25 to 45 in. lbs.) torque.
3. Install headlamp carrier with the four fasteners.
4. Install headlamp pins with the two pins.
5. Do not connect battery negative cable. Refer to Testing and Inspection/Procedures for Airbag System Test procedures.
pro multis · About Operation CHARM