Starter Feed Circuit Test

The following test will require a suitable volt-ohmmeter tester.
1. Connect tester to battery terminals following manufacturer's instructions.
2. Ensure all electrical accessories are off, transmission in Park or Neutral and the parking brake is set.
3. Turn ignition switch to Start position and observe tester.
4. If voltage reads between 9.6 and 12.4 volts and amperage draw reads above 250 amps, perform test shown under "Starter Feed Circuit Resistance Test."
5. If voltage reads 12.4 volts or more and amperage reads 0-10 amps, perform test shown under "Starter Control Circuit Test."
6. After starting system problems have been corrected, verify battery is fully charged. Disconnect all testing equipment and connect ignition system. Start vehicle several times to ensure system is operating correctly.