Power Mirrors

CIRCUIT OPERATION
The power mirrors use a single switch located in the left door trim panel. The feed for the system is supplied from the 10 Amp Ignition-Off Draw (IOD) fuse located in the junction block cavity 13. This fuse also supplies power for the radio, interior lamps and other components. Grounding for the power mirrors, along with power door locks and A/C Heater control, is provided through the Z1 circuit, which attaches to the instrument panel left side cowl.

The power mirror switch uses a Light Emitting Diode (LED) located in the switch for illumination. Power for the LED is supplied on circuit G5. The G5 circuit is protected by a 5 Amp fuse located in cavity 14 of the junction block. This fuse is HOT in the START/RUN position only.

Ground for the LED is supplied on the Z1 circuit. The termination point for the ground is at the instrument panel left side cowl.