Clearing Trouble Codes

With The Scan Tool
Connect the scan tool to the data link connector, then erase the diagnostic trouble codes according to scan tool instruction.

Without The Scan Tool
1. Remove the battery cable from the battery (-) terminal for 10 seconds or more, then reconnect the cable.
2. Warm up the engine, and then run it at idle for about 15 minutes.
1. Remove the link protector.
2. Check the slack in each of the inner cables in the accelerator cable, auto-cruise control cable and throttle cable. If the slack in an inner cable is excessive, or if there is no play loosen the adjusting bolts and the nuts in the throttle lever and each link, to release the throttle lever and each link. (The bolts and nuts should not be removed.)