Service Procedure

1. Raise the vehicle to working level on an appropriate hoist.

2. Remove the right front wheel and tire assembly.





3. Place the provided bracket over the right front brake hose block and then mark and center-punch the location for the bracket bolt hole as shown in Figure 1. Remove the bracket.

IMPORTANT:
If a brake line clip just to the rear of the block is already installed, remove and discard the clip before marking the bracket hole location.

4. Drill a 3/16" hole in the inner fender at the location marked in Step 3.

5. Install the supplied bracket and self-tapping screw (Figure 1). Tighten the bracket screw to 90 in-lbs (10 Nm).

6. Install the right front wheel and fire assembly. Tighten the lug nuts to 100 ft-lbs (135 Nm).

7. Lower the vehicle.