Output Speed Sensor

CAUTION: When disconnecting speed sensor connector, be sure that the weather seal does not fall off or remain in the old sensor.

NOTE: The output speed sensor is not interchangeable with the input speed sensor.

REMOVAL

Fig. 89:

1. Disconnect the output speed sensor connector (Fig. 89).
2. Unscrew and remove the output speed sensor.

Fig. 90:

3. Inspect the speed sensor O-ring and replace if necessary (Fig. 90).

INSTALLATION
1. Verify O-ring is installed into position (Fig. 90).
2. Install and tighten output speed sensor to 27 Nm (20 ft. lbs.) torque.
3. Connect speed sensor connector (Fig. 89).
4. Connect battery negative cable.