Power Mirror Switch: Testing and Inspection

1. Remove trim panel.
2. Disconnect wire harness connector from back of power mirror switch.
3. Disengage lock tabs at both ends of switch and remove power mirror switch from door trim panel.

Mirror Switch Test:

Mirror Switch Connector Pin-Call Out:

4. Using an ohmmeter, test for continuity between the terminals of the switch as shown in the Mirror Switch Test table.
5. If test results are not obtained as shown in the Mirror Switch Test table, replace the switch.
4. Using an ohmmeter, test for continuity between the terminals of the switch as shown in the Mirror Switch Test table.
5. If test results are not obtained as shown in the Mirror Switch Test table, replace the switch.