Air Register: Service and Repair

REAR HVAC LOUVER

REMOVAL

1. Using a trim stick (C-4755), pry edge of louver from bezel.
2. Remove HVAC louver from bezel.

Fig. 13:

3. Using a trim stick, pry lower edge of HVAC bezel away from headlining (Fig. 13) .
4. Remove louver from vehicle.

INSTALLATION

1. Place bezel in position in HVAC duct opening.
2. Push inward on bezel until clips snap in place. Verify that all four clips have been engaged to the bezel and that the bezel is flush to the headlining
3. Position HVAC louver to bezel.
4. Snap both ends of the louver into HVAC bezel.