Ignition Coil: Service and Repair

REMOVAL

Ignition Coil Removal:

1. Remove spark plug cables from coil. Always twist the coil boots to break the seal with the coil and pull straight back on the boot.
2. Remove ignition coil electrical connector.
3. Remove ignition coil mounting bolts, throttle cable bracket or clip.
4. Remove ignition coil.

INSTALLATION
1. Install ignition coil.
2. Tighten mounting screws to 12 Nm (105 in. lbs.) torque.
3. Transfer ignition cables to new coil pack. The coil pack towers and cables are numbered with cylinder identification.
4. Install ignition coil electrical connector.