Verification Test VER-6A

VERIFICATION TEST VER-6A

Applicability - All

LDP Monitor Verification

Use this test to verify that the LDP monitor symptom has been repaired and that the vehicle can be returned to the customer.

NOTE: If the Powertrain Control Module has been replaced and the correct VIN and mileage have not been programmed, a DTC will be set in the ABS, Airbag and the SKIM modules. In addition, if the vehicle is equipped with a Sentry Key Immobilizer Module (SKIM), Secret Key data must be updated to enable starting. Refer to GENERAL INFORMATION section for programming information for the PCM, SKIM and Transponder (ignition key).

1. Inspect the vehicle to ensure that all components are related to the repair are connected properly.

2. If any other DTC is present, refer to the symptom list for further diagnostic testing procedures.

3. With the DRB III, perform the LDP Monitor Test. Follow the instructions on the DRB III screen.

4. If the DTC resets, or the OBD II monitor fails after running, or if any other symptom or DTC is present, return to the symptom list and perform the appropriate diagnostic testing procedures. Refer to any Technical Service Bulletins that mat apply.

5. If the monitor runs and test does not fail, the condition is no longer present.

6. If there are no DTCs and all components are functioning properly, the repair is complete.