Center Sliding Door Roller: Service and Repair

CENTER HINGE

REMOVAL

1. Open sliding door to the mid point of its travel.
2. Support sliding door on a suitable lifting device.
3. Mark outline of center hinge of inner door panel to aid installation.
4. Remove bolts holding center hinge to sliding door.
5. Remove center hinge from sliding door.
6. Roll center hinge to rear of roller channel.
7. Separate center hinge from vehicle.

INSTALLATION

NOTE: Center hinge has an adjustable bolt for up/down alignment.

1. Place center hinge in position on vehicle.
2. Roll center hinge forward in roller channel.
3. Place center hinge in position on sliding door and align marks.
4. Install bolts to hold center hinge to sliding door.
5. Verify sliding door alignment and operation.