Instrument Panel Center Bezel

INSTRUMENT PANEL CENTER BEZEL

REMOVAL

1. Disconnect and isolate the battery negative cable.
2. Remove cup holder. Refer to Body, Instrument Panel, Cup Holder, Removal.
3. Insert the trim stick (special tool #C-4755) or equivalent between access cover and center bezel.
4. Carefully pry the access cover from the instrument panel.
5. Remove the cup holder track.
6. Using a trim stick or equivalent, gently pry out on the edge of the instrument panel center bezel and pull outward.
7. Disconnect the wire connectors to the accessory switches and HVAC control.
8. Remove the instrument panel center bezel from the vehicle.

INSTALLATION

1. Install the instrument panel center bezel from the vehicle.
2. Connect the wire connectors to the accessory switches and HVAC control.
3. Position the center bezel over the retaining slots and firmly snap the instrument panel center bezel into place.
4. Install the cup holder track.
5. Position the center bezel over the retaining slots and firmly snap into place.
6. Install cup holder. Refer to Body, Instrument Panel, Cup Holder, Installation.
7. Connect the battery negative cable.