Headlamp Unit Replacement

REMOVAL
Headlamp lens fogging is a normal condition and does not require service unless excessive or continual. Moisture will vent from tubes or vents located on the back of the lamp.
1. Release hood latch and open hood.
2. Disconnect and isolate the battery negative cable.

Fig.28 Headlamp Housing:

3. Remove jackscrews attaching headlamp to body (Fig. 28).
4. Remove headlamp from body.
5. Disconnect wire connector from headlamp and parking, side marker, and turn signal lamps.
6. Remove headlamp housing from vehicle.

INSTALLATION
Headlamp lens fogging is a normal condition and does not require service unless excessive or continual. Moisture will vent from tubes or vents located on the back of the lamp.
1. Place headlamp housing in position on vehicle.
2. Connect wire connectors to headlamp, parking, side marker, and turn signal lamps.
3. Place headlamp in position on body.
4. Install screws to attach headlamp to body.
5. Connect the battery negative cable and close hood.
6. Verify headlamp operation and alignment.