Solenoid/Pressure Switch Assembly
SOLENOID/PRESSURE SWITCH ASSYREMOVAL
NOTE: If the Solenoid/Pressure Switch Assembly is being replaced, the Quick Learn Procedure must be performed.
(1) Raise vehicle on hoist.
(2) Remove valve body assembly from transaxle.
(3) Remove Solenoid/Pressure Switch Assembly retaining screws from solenoid (Fig. 352).
(4) Remove Solenoid/Pressure Switch Assembly and screen from valve body (Fig. 353).
INSTALLATION
NOTE: If the Solenoid/Pressure Switch assembly is being replaced, the Quick Learn Procedure must be performed.
(1) Install Solenoid/Pressure Switch Assembly and screen to the separator and transfer plates (Fig. 353).
(2) Install and tighten retaining screws (Fig. 352) to 6 Nm (35 inch lbs.) torque.
(3) Install valve body.