Rear Door Window Glass: Service and Repair

DOOR GLASS

REMOVAL

1. Remove door trim panel.
2. Remove watershield as necessary.
3. Raise door glass to gain access to roller channel to glass fasteners through holes in inner door panel.

Fig. 3:

4. Loosen lift plate nuts attaching regulator roller channel to glass (Fig. 3).
5. Slide roller channel rearward to allow lift plate nuts to pass through key hole slots in channel.
6. Remove glass from roller channel.
7. Raise glass upward and out of the opening at top of door.

INSTALLATION

1. Lower glass into opening at top of door.
2. Place glass in position against roller channel.
3. Insert lift plate nuts into key hole slots in roller channel and slide channel forward to locked position.
4. Tighten nuts to attach regulator roller channel to glass and lift plate.
5. Install upper trim retainer channel.
6. Install watershield.
7. Install door trim panel.