Sunroof / Moonroof Module: Service and Repair

SUNROOF ELECTRONICS MODULE ASSEMBLY

REMOVAL
1. Remove headliner.
2. Remove sunroof assembly.
3. Remove two rail screws at rear of module first.
4. While supporting module assembly, remove the six module attaching screws.
5. Remove module assembly from vehicle and place on clean work area.
6. Remove three motor assembly retaining screws from bottom side of motor, and remove motor assembly.
7. From top side of module assembly, remove one attaching screw from electronics module.
8. Disconnect electrical connector from module assembly.
9. Cut and remove retaining tape to release wire from bundle.
10. Remove old timing module.

INSTALLATION
1. Check glass assembly position. Adjust to full closed position. Insert pin into holes in lift arm assembly to check position.
2. Check electronics module and ensure it's in the full closed position.
3. Set new electronic module in position on top side of motor mounting bracket engaging drive cables with pinion gear in electronics module.
4. Install one screw to attach electronics module to motor bracket. Tighten screw to 2.5 - 3.5 Nm (22 - 31 in. lbs.) torque.
5. Install motor assembly to motor bracket and electronics module with three screws. Tighten screw to 2.5 - 3.5 Nm (22 - 31 in. lbs.) torque.
6. Connect electrical connector to module assembly wire harness. Secure any loose wires.
7. Install sunroof module assembly.
8. Test sunroof operation, adjust as necessary.
9. Install headliner.
10. Install A-pillar trim, sun visors, and map lamps/mini console.
11. Install sunroof opening trim lace.