Wiper Motor: Service and Repair

REMOVAL
The Wiper Module Assembly must be removed to service the wiper motor.
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Remove wiper module. Refer to Electrical, Wipers and Washers, Wiper Module REMOVAL.
3. Disconnect wiper module master link from motor crank by carefully using a ball and socket wedge. Do not damage ball and socket or seal when using wedge.

Fig. 19 Wiper Motor Retaining Bolts:

4. Remove three retaining bolts from the wiper motor.
5. Remove wiper motor from wiper module.

INSTALLATION
1. Place wiper motor in position onto wiper module.
2. Install the three retaining bolts to the wiper motor.
3. Connect the wiper module master link to the motor crank by carefully snapping together. Do not damage ball and socket or seal.
4. Install the wiper module. Refer to Electrical, Wipers and Washers, Wiper Module INSTALLATION.
5. Connect the negative battery cable remote terminal to the remote battery post.