Power Mirror Control Module: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the driver side front bucket seat retaining nuts from under the vehicle.
3. Lift the drivers seat up and out of the mounting holes in the floor pan and lay the seat rearward to access the module located under the seat. It is not necessary to disconnect the seat electrical, just use care not to damage the wiring by over-extending.
4. Disconnect the memory/mirror seat module electrical connectors. Depress the retaining tab and pull straight apart.
5. Remove the module retaining bolts and remove the module from the bracket.

INSTALLATION
1. Position and install the module retaining bolts.
2. Connect the memory/mirror seat module electrical connectors.
3. Position the drivers seat in the mounting holes in the floor pan.
4. Install the driver side front bucket seat retaining nuts from under the vehicle.
5. Connect the battery negative cable.