Control Module: Service and Repair

REMOVAL




1. Disconnect the negative battery cable.
2. Remove the passenger floor mat and pull the carpet back in the front portion of the footwell.
3. Remove the plastic nuts holding the base plate (3) to the passenger footwell and pull the base plate (3) down.
4. Remove the screws holding the transmission control module (1) to the base plate (3).
5. Disconnect the electrical connectors and remove the transmission control module (1).

INSTALLATION




1. Connect the electrical connectors to the transmission control module (1).
2. Install the screws holding the transmission control module (1) to the base plate (3).
3. Turn the base plate (3) and realign it with the mounting studs on the vehicle floor.

NOTE: Be sure not to pinch or cause interference with the wiring harnesses while locating the base plate to the vehicle floor studs.

4. Install the plastic nuts and secure the base plate (3) to the passenger side lower dash panel.
5. Push the carpet in the front part of the passenger footwell up into its original position and install the passenger floor mat.
6. Connect the negative battery cable.