Sunroof Module

ELECTRONIC CONTROL MODULE

REMOVAL
1. Remove sunroof module assembly (Refer to BODY/SUNROOF/MODULE ASSEMBLY - REMOVAL).
2. Cut wire retaining tape near motor being careful not to cut wires.
3. Disconnect drive motor's wire harness.

Fig. 2 Control Module:

4. Remove three motor assembly retaining screws from bottom side of motor, and remove motor assembly.
5. From top side of module assembly remove one attaching screw from control module.
6. Disconnect the two wire connectors from electronic control module assembly.
7. Remove control module.

INSTALLATION

Fig. 3 Lift Arm Positioning:

1. Check glass assembly position. Adjust to full closed position. Insert pin into holes in lift arm assembly to check position.
2. Check electronics module and ensure it's in the full closed position.
3. Set new electronic module in position on top side of motor mounting bracket engaging drive cables with pinion gear in electronics module.
4. Install one screw to attach electronics module to motor bracket. Tighten screw to 3 Nm (27 in.lbs.) torque.
5. Install motor assembly to motor bracket and electronics module with three screws. Tighten screw to 3 Nm (27 in.lbs.) torque.
6. Connect electrical connectors to module assembly wire harness. Secure any loose wires.
7. Install sunroof module assembly (Refer to BODY/SUNROOF/MODULE ASSEMBLY - INSTALLATION).