Sunroof Module Assembly

SUNROOF MODULE ASSEMBLY

REMOVAL
1. Move glass panel to the fully closed position.
2. Disconnect battery negative cable.
3. Recline both front seats.
4. Remove sunroof opening trim lace (Refer to BODY/SUNROOF/OPENING TRIM LACE - REMOVAL).
5. Remove control switch (Refer to BODY / SUNROOF/CONTROL SWITCH - REMOVAL).
6. Remove headliner (Refer to BODY/INTERIOR/HEADLINER - REMOVAL) and disconnect sunroof wire harness.
7. Disconnect the four drain tubes from sunroof housing.
8. Loosen fasteners attaching sunroof module assembly
9. Remove the two bracket screws at the rear of the module.

Fig. 1 Sunroof Module Assembly:

10. With the aid of a helper, support the sunroof and remove the remaining six fasteners attaching sunroof module assembly to roof panel.
11. Remove sunroof module from vehicle.

INSTALLATION
1. Raise sunroof module assembly and guide it carefully into position.
2. While supporting the sunroof module tighten the six module attaching screws. Tighten to 9.5 Nm (84 in.lbs.) torque.
3. Install the two bracket screws at the rear of the module. Tighten to 9.5 Nm (84 in.lbs.) torque.
4. Connect the drain tubes to the sunroof.
5. Connect wire harness.
6. Install headliner (Refer to BODY/INTERIOR/HEADLINER - INSTALLATION).
7. Install sunroof control switch (Refer to BODY/SUNROOF/CONTROL SWITCH - INSTALLATION).
8. Connect battery negative cable.
9. Test sunroof operation, adjust as necessary (Refer to BODY/SUNROOF/GLASS PANEL - ADJUSTMENTS).
10. Install sunroof opening trim lace position (Refer to BODY/SUNROOF/OPENING TRIM LACE - INSTALLATION)