Cruise Control Servo Cable: Service and Repair
REMOVAL1. Remove the air cleaner lid, and makeup air hose.
2. Remove the negative battery cable.
3. Remove the engine cover and throttle control shield, if equipped.
Fig. 6 Speed Control System:
4. Remove two nuts attaching speed control cable and mounting bracket to servo.
5. Remove servo from the mounting bracket.
6. Disconnect electrical connectors and vacuum hose.
Fig. 3 Cable Cup:
7. Remove retaining clip holding cable to servo.
Fig. 4 Throttle Cable And Speed Control Cable:
8. Remove throttle cable clasp from the throttle body cam.
9. Remove speed control cable from throttle cam by sliding clasp out hole used for throttle cable.
Fig. 5 Retaining Tabs:
10. Compress the retaining tabs on the cables and slide cables out of bracket.
INSTALLATION
1. Install cable core wire through center hole on bracket, onto servo center post.
Fig. 3 Cable Cup:
2. Install retaining clip to cable at servo.
3. Slide cable bell housing over servo mounting studs through the bracket.
4. Install 2 nuts, tighten to 7 Nm (60 in. lbs.).
Fig. 4 Throttle Cable And Speed Control Cable:
5. Slide cables into throttle cable bracket and engage retaining tabs.
6. Rotate the throttle cam forward to the wide open position and install speed control cable clasp.
7. Rotate the throttle cam forward to the wide open position and install throttle cable clasp.
8. Install engine cover and throttle control shield, if equipped.
9. Install the negative battery cable.
10. Install the air cleaner lid, makeup air hose.