Service Procedure

1. Using a trim stick placed between the turning loop cover and the release button, pry the ~ of the driver's side turning loop bolt cover open and then remove the cover (Figure 1).

2. Tighten the turning loop bolt to 30 ft-lbs (40 N.m).

3. Install the turning loop bolt cover by aligning catches on the bottom of the cover with the turning loop bracket and then snapping the cover over the top of the bracket. Ensure that the cover is fully installed.

NOTE:
There should be no gap between the turning loop cover and the turning loop. Pinch the turning loop and cover with your finger and thumb to fully seat the cover.

NOTE:
If the turning loop cover was damaged during removal, replace it with a new cover (P/N 5HF07BD1AC).

4. Repeat Steps 1-3 for the passenger side turning loop bolt.