Rear Door Window Glass: Service and Repair

GLASS

REMOVAL




1. Remove the trim panel from the inside of the rear door.
2. Remove the inner belt weatherstrip from the rear door.
3. Remove the watershield from the inside of the rear door. Refer to Rear Door Panel.
4. Remove the glass channel and bracket from the inside of the rear door. Refer to Window Track.
5. Using the regulator, adjust the rear door glass (1) position up or down as required for access to the two window regulator glass clamps (2).
6. Loosen the screw (2) in each of the glass clamps far enough to release the glass.




7. From the outside of the rear door, lift the glass (1) upward far enough to disengage it from the two glass clamps (2).
8. Lift the glass upward and out from the top of the door shell to unload the glass from the door.

INSTALLATION




1. From the outside of the rear door, insert the rear door glass (1) into the top of the door shell to load the glass into the door.
2. Engage the glass into the two window regulator glass clamps (2).




3. Using the regulator, lower the window as required for access to the two window regulator glass clamp screws (3).
4. Tighten the screw in each of the glass clamps. Tighten the screws to 10 N.m (90 in.lbs.).
5. Reinstall the glass channel and bracket onto the inside of the rear door. Refer to Window Track.
6. Reinstall the watershield onto the inside of the rear door.
7. Reinstall the inner belt weatherstrip onto the rear door.
8. Reinstall the trim panel onto the inside of the rear door.