9003/9004
9003/9004 POWER TOP CONTROL MODULE EEPROM ERROR9003/9004 Power Top Control Module EEPROM Error:
WHEN MONITORED
Continuous with the ignition on.
SET CONDITION
An attempt to program/write to the internal EEPROM failed.
POSSIBLE CAUSES
- Power top control module
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.
DIAGNOSTIC TEST
1. Power Top Control Module (PTCM)
NOTE: This DTC indicates an internal PTCM fault.
With the DRBIII(R), read and record the PTCM DTCs and then erase the PTCM DTCs
Perform 3 ignition key cycles, leaving the ignition key on for a minimum of 30 seconds per cycle.
With the DRBIII(R) , read the PTCM DTCs.
Q: Did this DTC set again?
YES: Replace the Power Top Control Module. Perform POWER TOP CONTROL MODULE VERIFICATION TEST. Power Top Verification Test
NO: The condition that caused this DTC to set is currently not present. Perform POWER TOP CONTROL MODULE VERIFICATION TEST. Power Top Verification Test