Do you have access to Mitchell1 Prodemand? If you are willing to share user/password (we can pay $250), please get in contact with us ASAP: email operation-charm [[at]] tuta.io or click to submit anonymously. (I know, we said we wouldn't ask any more...but it's important!)

No Communication to Instrument Cluster

WHEN MONITORED
With the ignition on.

SET CONDITION
Serial Communication K2 failure between the A/C Heater Control Module and the Instrument Cluster.

POSSIBLE CAUSES
- Serial communication K2 circuit open
- Instrument cluster
- A/C heater control module

Diagnostic Test

1. MEASURE THE RESISTANCE OF THE SERIAL COMMUNICATION K2 CIRCUIT

Turn the ignition off.
Disconnect the Instrument Cluster harness connector.

NOTE:
- Check connector - Clean/repair as necessary. Disconnect the A/C Heater Control Module harness connector.

- Check connector - Clean/repair as necessary. Measure the resistance of the Serial Communication K2 circuit from the Instrument Cluster harness connector to the A/C Heater Control Module harness connector.

Q: Is the resistance below 5.0 ohms?

YES: Replace the A/C Heater Control Module. Perform BODY VERIFICATION TEST. Body Verification Test
NO: Repair the Serial Communication K2 circuit for an open. Perform BODY VERIFICATION TEST. Body Verification Test