With an Inclinometer

INSPECTING AND ADJUSTING VEHICLE LEVEL AT FRONT AND REAR AXLES
1. Observe the general information on chassis alignment inspection.
2. Inspect the vehicle level at the front axle by performing the following:
- Insert measuring device between the retaining bolts of the lower control arm bearing.
- Position the contact arm of measuring device on the control arm and read off the plumb value of vehicle level, viewed from the center of the vehicle.
3. Inspect the vehicle level at the rear axle by performing the following:
1. Loosen right rear frame brace and swivel to one side.
2. Position contact arm on the rear axle shaft and read off the plumb value of the vehicle level, viewed from the center of the vehicle.

Note: If the vehicle level at the front or rear axle is outside the tolerance, adjust the vehicle level by changing the springs or spring rubber mounts.

4. Adjust the vehicle level at the front and rear axles.