Holding Clutch B2
HOLDING CLUTCH B2DISASSEMBLY
1. Remove the snap ring (1).
2. Take the multi-disc pack (2) and the disc spring (3) out of the B3 piston/B2 outer disc carrier (8). The B3 piston/B2 outer disc carrier (8) for the multi-disc holding clutch B2 is the piston for the multiple-disc holding clutch B3 at the same time.
3. Place Special Tool 8900 on the piston back pressure spring disc (14) and compress the spring until the groove for the snap-ring is exposed.
4. Remove the snap-ring (16).
5. Remove the spring plate (15) and the piston back pressure disc spring (14).
6. Separate the piston guide ring (13) and the B2 piston (10) from the B3 piston/B2 outer disc carrier (8) by blowing compressed air into the bore.
7. Press the piston guide ring (13) out of the B2 piston (10).
8. Separate the B2 and B3 piston guide (4) from the B3 piston/B2 outer disc carrier (8) by blowing compressed air into the bore.