Fluid Drain and Fill
STANDARD PROCEDURE- FLUID DRAIN AND FILL1. Raise and support the vehicle.
2. Remove the fill plug (1).
3. Place a suitable drain pan below the drain plug (2). Remove the drain plug (2) and allow the transmission to drain completely.
4. Install the drain plug (2) and tighten to 60 Nm (44 ft. lbs.).
5. Remove the drain pan. Fill the transmission with the specified fluid.
6. Install and tighten the fill plug (1) to 50 Nm (37 ft. lbs.).
7. Lower the vehicle.
STANDARD PROCEDURE - CHECKING FLUID LEVEL
1. Raise and support the vehicle.
2. Remove the transmission fill plug (1).
3. The full fluid level should be at the base of the fill plug threaded hole. If the fluid is low, check for visible transmission fluid leaks and top off the fluid level.
4. Install and tighten the fill plug (1) to 50 Nm (37 ft. lbs.).
5. Lower the vehicle.