Charge Air Cooler to Throttle Body Hose
CHARGE AIR COOLER TO THROTTLE BODY HOSEREMOVAL
1. Remove air cleaner housing.
2. Disconnect negative battery cable.
3. Disconnect positive battery cable.
4. Remove battery and battery tray.
5. Remove battery tray support bracket.
6. Loosen hose clamp at charge air cooler (Fig. 30).
7. Dislodge hose from charge air cooler.
8. Disconnect Inlet Air Temperature (IAT) sensor connector (Fig. 31).
9. Disconnect Throttle Inlet Pressure (TIP) hose from charge air cooler hose (Fig. 31).
10. Loosen hose clamp at throttle body
11. Remove charge air cooler hose.
INSTALLATION
1. Position hose to mounting location.
2. Connect hose to throttle body.
3. Connect hose to charge air cooler (Fig. 30).
4. Tighten hose clamps to 1.7 Nm (15 in. lbs.).
5. Connect Throttle Inlet Pressure (TIP) hose to charge air cooler hose (Fig. 31).
6. Connect Inlet Air Temperature (IAT) sensor connector (Fig. 31).
7. Install battery tray support bracket.
8. Install battery tray and battery.
9. Connect positive battery cable.
10. Connect negative battery cable.
11. Install air cleaner housing.