Washer Pump Motor Replacement

REMOVAL
1. Open hood.

Fig. 12 Battery Negative Cable - Remove/Install:

2. Disconnect and isolate the battery negative cable.

Fig.9 Front Wiper Arm Remove/Install:

3. Using a trim stick (special tool #C-4755) or equivalent, gently pry up on the wiper arm nut cap and remove.
4. Remove wiper arm retaining nut.
5. Remove the arm from the pivot using a rocking motion while the arm is in an over/centered position.
6. Remove the right cowl cover.
a. Remove the rear engine compartment seal at the cowl.
b. Remove the three push retainers to the right side cowl cover and remove from vehicle.

7. Remove three reservoir retaining screws.
8. Disconnect the pump wire connector.
9. Disconnect the washer hose connections.
10. Lift washer reservoir out of cowl area and drain into bucket.
11. Gently pry pump away from reservoir and out of grommet. Care must be taken not to puncture reservoir.
12. Remover rubber grommet from reservoir.

INSTALLATION

CAUTION: A new grommet must be used every time the pump is removed/installed from the reservoir to prevent possible leaks in the future.

1. Install new grommet into the reservoir.
2. Insert pump into pump grommet and firmly snap into reservoir.
3. Place reservoir into cowl area and connect the washer hoses.

NOTE: The hose with the white stripe goes on the white side of the pump and the black hose on the black side of the pump.

4. Connect the pump wire connector.
5. Install the three reservoir retaining screws. Torque screws to 8 Nm (70 in. lbs.).

6. Install the right cowl cover.
a. Place the right side cowl cover into position and install the two push retainers.
b. Install the rear engine compartment seal at the cowl.

Before installation of the front wiper arms, activate the wiper system to ensure the front wiper module is in the PARK position. Position wiper arms so that the tip of the driver's blade and the middle of the passenger's blade is on the park line on the windshield (Refer to ELECTRICAL/WIPERS/WASHERS/WIPER ARMS - ADJUSTMENTS).

7. Place the arm on the pivot while the arm is in an over/centered position.
8. Install the wiper arm retaining nut and torque to 21 Nm (190 in. lbs.).
9. Install the wiper arm nut cap.
10. Connect the battery negative cable.
11. Close hood.
12. Verify vehicle and system operation.