Front And Rear Door Opening Weatherstrip
FRONT AND REAR DOOR OPENING WEATHERSTRIPREMOVAL
COUPE
1. Open front/rear door.
2. Remove door opening sill plate.
3. Pull body mounted weatherstrip from fence around door opening.
CONVERTIBLE
1. Remove door sill scuff plate. Refer to Trim Panel.
2. Remove four push pin fasteners (2) at the B-pillar end the weatherstrip.
3. Pull weatherstrip from vehicle.
INSTALLATION
COUPE
1. Position weatherstrip at the B-pillar upper corner.
2. Engage front/rear weatherstrip on the fence at upper B-pillar and work down the B-pillar.
3. Engage weatherstrip along the header and down the A-pillar/C-pillar.
4. Engage weatherstrip along the sill. There may be slack material work it to the front of the opening.
5. Verify weatherstrip sealing.
CONVERTIBLE
1. Place weatherstrip into position.
2. Ensure weatherstrip is set in place.
3. Install four push pin fasteners (2) at the B-pillar end the weatherstrip.
4. Install door sill scuff plate. Refer to Trim Panel.