Installation

VALVE BODY

INSTALLATION

NOTE: To ease installation of the valve body, turn the manual valve lever fully clockwise.





1. Install overdrive and underdrive accumulators and springs as previously removed (Fig. 383).








2. Guide park rod rollers into guide bracket while installing valve body to the transaxle case (Fig. 381) (Fig. 382).





3. Install the valve body-to-case bolts (Fig. 380) and torque to 12 Nm (105 inch lbs.).





4. Install the oil filter (Fig. 379). Inspect the O-ring for damage and replace as necessary.





5. Install an 1/8" bead of RTV as shown in (Fig. 378) and install pan to case.





6. Install oil pan bolts (Fig. 377) and torque to 19 Nm (165 inch lbs.) torque.
7. Lower vehicle.





8. Install manual valve lever to manual shaft (Fig. 376).
9. Install gearshift cable to manual valve lever (Fig. 376).





10. Install the battery tray (Fig. 375).





11. Install the battery and hold down clamp (Fig. 374).





12. Install air cleaner assembly (Fig. 373).
13. Connect battery cables.
14. Fill transaxle with fluid.