Differential

DIFFERENTIAL

DISASSEMBLY





1. Remove differential side bearings. Set up Tool 5048, with Collets 8926 as shown in (Fig. 135).





2. Using suitable socket and wrench, remove differential side bearing(s) (Fig. 136).





3. Remove twelve (12) differential ring gear-to-case bolts (Fig. 137). Remove differential ring gear from case.
4. Remove pinion shaft, and remove all pinion gears, side gears, and thrust washers (Fig. 137).

ASSEMBLY
1. Install differential pinion and side gears with washers to case (Fig. 137). Install pinion shaft. Pinion shaft is retained by ring gear.
2. Install differential ring gear (Fig. 137). Install and torque twelve (12) ring gear-to-case bolts to 85 Nm (63 ft. lbs.).
3. Install differential to arbor press bed.





4. Press on differential side bearing(s) using Tool 8953 mounted onto Tool C-4171. Press until bearing bottoms on case (Fig. 138).