Transaxle Housing

TRANSAXLE HOUSING

DISASSEMBLY





1. Remove reverse shaft needle bearing using Tools 8915 and 8911 (Fig. 246).





2. Remove differential bearing cone using Tools 8915 and 8913 (Fig. 247).








3. Drive out input and intermediate shaft sealed roller bearings using Tools C-4171 and 6954 (Fig. 248) (Fig. 249).

ASSEMBLY

NOTE: Input and intermediate shaft sealed roller bearings do not get installed until transaxle assembly.





1. Using Tools C-4171 and 8924, install reverse shaft needle bearing (Fig. 250). Drive until tool bottoms on case.





2. Using Tools C-4171 and 8866, install differential bearing race (Fig. 251). Drive until race bottoms in case.