Removal and Replacement

BATTERY

WARNING:
- A SUITABLE PAIR OF HEAVY DUTY RUBBER GLOVES AND SAFETY GLASSES SHOULD BE WORN WHEN REMOVING OR SERVICING A BATTERY.
- REMOVE METALLIC JEWELRY TO AVOID INJURY BY ACCIDENTAL ARCING OF BATTERY CURRENT.


REMOVAL
1. Make sure ignition switch is in OFF position and all accessories are turned OFF.
2. Remove the rear compartment floor, trim panel to gain access to the battery.




3. Disconnect the battery negative cable (2) from the battery terminal.
4. Disconnect the battery positive cable (1) from the battery terminal.
5. Unlatch the battery retention strap (4).

CAUTION: Use care when disconnecting the battery vent tube from the battery. The vent tube nipple is made of plastic and is easily damaged if not disconnected properly.




6. Gently disconnect the battery vent tube from the battery nipple.




7. Remove the battery hold down clamp and remove the battery from the vehicle.

INSTALLATION




1. Position the battery in the battery tray.




2. Install the battery hold down clamp and bolt. Torque the bolt to 4 N.m (35 in. lbs.).

CAUTION: Use care when connecting the battery vent tube to the battery. The vent tube nipple is made of plastic and is easily damaged if not connected properly.




3. Gently connect the battery vent tube to the battery nipple.




4. Latch the battery retention strap (4).
5. Connect the battery positive cable (1).
6. Connect the battery negative cable (2).
7. Install the rear compartment floor trim panel.