B1BA8

B1BA8-OCM SYSTEM OUT OF CALIBRATION/NOT CALIBRATED


WHEN MONITORED
While the CAN bus ignition status is IGN_RUN or status not available.

SET CONDITION
This DTC will set if the module or the technician initiated a system verification (rezero) process and the system verification process was not successfully completed.

DIAGNOSTIC TEST

1. PERFORM OCCUPANT CLASSIFICATION MODULE SYSTEM VERIFICATION TEST
Verify that the passenger seat is empty.
Verify that all of the Seat Weight Sensor mounting screws are torqued to specification.

NOTE: Failure to follow the test instructions or aborting the test will cause faults to set when performing the Occupant Classification Module System Verification Test. To prevent faults due to process errors: Verify That All Tests Steps That Led You Here Were Performed As Directed; Verify That The Ignition Is In Run; Wait 30 Seconds After Changing The Seat Weight Before Proceeding To Allow The System To Stabilize; Only Press Scan Tool Buttons When Directed To Do So; & Perform The Occupant Classification Module System Verification Test To Completion.
With the scan tool in OCM, select More Options, select System Tests, and select Occupant Classification Module System Verification Test. Run the test by following the instructions displayed on the scan tool. When the test is complete, proceed as follows.
With the scan tool, read OCM DTCs.

Q: Does the scan tool display any active DTCs?

Yes - B1BA8 is Active
Perform the Diagnosis/Checkout Procedure For Seat Weight Sensors. Testing and Inspection

Yes Other DTCs Present
Diagnose and repair the DTCs.

No Active DTCs Present
Perform OCS VERIFICATION TEST - VER 1. OCS Verification Test