Right D-Pillar Trim Panel

RIGHT D PILLAR TRIM PANEL

REMOVAL

1. Remove rear header trim cover.
2. Remove liftgate sill plate.
3. Remove second row seat belt turning loop on long wheel base vehicle.
4. Remove bolt attaching second row seat belt, anchor to quarter on short wheel base vehicle.
5. Disengage hidden clips attaching trim to D-pillar.
6. Remove D-pillar trim panel from D-pillar.
7. Disconnect speaker wire connector, if equipped.
8. Pass second row seat belt, if equipped, through slot in trim panel on short wheel base vehicle.
9. Remove D-pillar trim from vehicle.

INSTALLATION

1. Position D-pillar trim on vehicle.
2. Pass second row seat belt, if equipped, through slot in trim panel on short wheel base vehicle.
3. Connect speaker wire connector to speaker, if equipped.
4. Align locating pins on backside of trim panel to mating holes in D-pillar.
5. Engage hidden clips attaching trim to D-pillar.
6. Install screws attaching trim panel to attaching bracket on short wheel base vehicle.
7. Install quarter trim bolster on short wheel base vehicle.
8. Install bolt to attach second row seat belt, if equipped, anchor to quarter on short wheel base vehicle. Tighten all seat belt bolts to 39 N.m (29 ft.lbs.) torque.
9. Install second row seat belt turning loop on long wheel base vehicle.
10. Install liftgate sill plate.
11. Install rear header trim cover.