Assembly

ASSEMBLY




1. Position the Steering Control Module (SCM) onto the multi-function switch.




2. Install the multi-function switch and SCM in the SCCM shroud and tighten the three screws (1) from the bottom.




3. Install the steering column telescoping lever (3).




4. Install the speed control switch (1).




5. If equipped with manual telescoping column, install the strut (1).




6. If equipped with electronic telescoping column, install the electric tilt lever and switch (3).




7. If equipped with ESP, install the steering angle sensor and screw (3) located at the six o'clock position.




8. Install the clockspring and screws (1) leaving one out so it will not unwind.
9. Install the SCCM on the steering column and tighten the one clockspring screw (1) that was left loose.