Installation - Bulb

INSTALLATION - BULB

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.

NOTE: The overhead console reading lamp switches and bulb holders are serviced as a unit with the overhead console wire harness.





1. Align the ends of the bulb (2) with the two bulb holders within the overhead console lamp housing.

2. Carefully press the bulb firmly and evenly into the bulb holders until it snaps into place.





3. Position the lens (1) to the overhead console housing (4) and snap the outboard edge back into place.

4. Position the forward edge of the bezel (2) between the two lenses, then press the rear edge of the bezel firmly and evenly until it snaps back into the housing.

5. Reconnect the battery negative cable.