B190F

B190F-DRIVER WINDOW SWITCH CIRCUIT HIGH-DDM





For a complete wiring diagram refer to Diagrams/Electrical.

- When Monitored:

Continuously

- Set Condition:

When the Driver Express Switch Driver Window Mux circuit is over 5.6 volts for over 100 ms.





Diagnostic Test

1.TEST FOR INTERMITTENT CONDITION

With the scan tool, record and erase DTC's

Operate the Driver Window Switch in both positions several times.

Cycle the ignition from on to off.

Turn the ignition on.

With the scan tool, read DTC's.

Does the scan tool display B190F-DRIVER WINDOW SWITCH CIRCUIT HIGH?

Yes

- Go To 2

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

2.DRIVER WINDOW/DOOR LOCK SWITCH SHORTED





With the scan tool, erase DTC's.

Disconnect the Driver Window/Door Lock Switch C2 connector.

Turn the ignition on.

With the scan tool, read DTC's.

Does the scan tool display B190F-DRIVER WINDOW SWITCH CIRCUIT HIGH?

No

- Replace the Driver Window/Door Lock Switch.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

Yes

- Go to 3

3.(Q221) DRIVER EXPRESS SWITCH DRIVER WINDOW MUX CIRCUIT SHORT TO VOLTAGE





Turn the ignition off.

Disconnect the Driver Door Module C2 connector.

Turn the ignition on.

Measure the voltage between ground and the (Q221) Driver Express Switch Driver Window Mux circuit in the Driver Door Module C2 connector.

Is there any voltage present?

Yes

- Repair the (Q221) Driver Express Switch Driver Window Mux circuit for a short to voltage.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Replace the Driver Door Module.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test