Condition - Non-Parallel Gap Between Door and Quarter Glasses

GLASS ALIGNMENT DIAGNOSIS

CONDITION - NON-PARALLEL GAP BETWEEN DOOR AND QUARTER GLASSES





1. Verify that the door glass and quarter glass adjustment procedures have been checked.

2. Apply masking tape to outside glass surface in locations (10).

3. Mark tape at the two locations and then drop top.

4. With vehicle running, drive quarter glass full up and then drive door glass up and mark tape at the two locations (10).

5. If gap not parallel to within 1.5 mm, loosen cross car screw (8), cross car screw (7) and cross car screw (6) and rotate quarter glass regulator with quarter glass to body and then tighten to 8.5 Nm (75 in. lbs.).

6. Repeat test using Steps 3 thought 5, if still can not get parallelism within 1.5 mm then proceed to Step 7.

7. Remove quarter glass regulator with glass and increase slot size, forward 2.0 mm at cross car screw location (6) only.

8. Install the quarter glass regulator with glass and repeat Step 1 thought 5.