Installation

INSTALLATION

FRONT MOUNTED

LEFT FRONT SATELLITE ACCELERATION SENSOR




1. Position SAS (1) on side radiator support and install the two retaining screws (2). Tighten the screws to 10.5 Nm (92 in. lbs.).

2. Connect the SAS electrical connector (3).

3. Install the front lower grille.

WARNING: Do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.

RIGHT FRONT SATELLITE ACCELERATION SENSOR




4. Position SAS (1) on side radiator support and install the two retaining screws (3). Tighten the screws to 10.5 Nm (92 in. lbs.).

5. Connect the SAS electrical connector (2).

6. Install the front lower grille.

WARNING: Do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.

SIDE MOUNTED




1. Position the Satellite Acceleration Sensor (SAS) (1) in B-pillar (electrical connector (3) facing down in vehicle) and install the retaining nuts (2). Tighten the nuts to 8 Nm (70 in. lbs.).

2. Connect the SAS electrical connector (3).

3. Install the lower B-pillar trim.

WARNING: Do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.