Procedures

Removal


NOTE: LHD model shown in illustrations. RHD model similar.

NOTE: Illustration shown with instrument panel removed for clarity.

1. Remove the glove box bin.






2. Disengage the two retaining tabs (1) that secure the particulate air filter cover (2) to the passenger side of the HVAC housing (3) and remove the cover.






3. Remove the particulate air filter (1) from the HVAC housing (2) by pulling the filter element straight out of the housing.

Installation


NOTE: The particulate air filter is labeled with an arrow to indicate air flow direction through the filter. Make sure to properly install the particulate air filter. Failure to properly install the filter will result in the need to replace the filter sooner than required by design.

NOTE: LHD model shown in illustrations. RHD model similar.






1. Install the particulate air filter (1) into the opening in the HVAC housing (2). Insert the particulate air filter directly into the housing with the arrow on the filter pointing to the floor.






2. Position the particulate air filter cover (2) to the HVAC housing (3) and engage the two retaining tabs (1) that secure the cover to the housing. Make sure the retaining tabs are fully engaged.

3. Install the glove box bin.