Removal

REMOVAL





1. Disconnect and isolate the battery negative cable.

2. Remove both the upper and lower shrouds from the steering column.

3. Remove the screw (2) that secures the right multi-function switch (1) to the mounting bracket integral to the right side of the clockspring (3) on the steering column.

4. Slide the switch away from the clockspring far enough to disengage the slide tab on the bottom of the switch housing from the channel formation in the mounting bracket.





5. Disconnect the jumper wire harness connector (1) from the connector receptacle on the inboard end of the right multi-function switch (2).

6. Remove the switch from the clockspring (3).