B2328

B2328-WASHER FLUID LEVEL SENSOR INPUT CIRCUIT HIGH

For a complete wiring diagram consult Diagrams/Electrical.


- When Monitored:
With the ignition on.

- Set Condition:
When the TIPM detects a HIGH condition.








Diagnostic Test


1. INTERMITTENT CONDITION
Turn the ignition on.
With the Scan Tool, clear all TIPM DTC's.
Turn the Wiper Washers on.
With the Scan Tool, read the Wiper DTC's.
Does the Scan Tool read: B2328-WASHER FLUID LEVEL SENSOR INPUT CIRCUIT HIGH?

Yes


- Go To 2


No


- The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test




2. W1 WASHER FLUID LEVEL SENSOR CONTROL CIRCUIT SHORT TO VOLTAGE
Turn the ignition off.
Disconnect the Washer Fluid Level Sensor connector.
Disconnect the TIPM C2 connector.
Measure the voltage of the (W1) Washer Fluid Level Sensor control circuit.
Is the voltage above 10.0 volts?

Yes


- Repair the (W1) Washer Fluid Level Sensor control circuit.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test


No


- Replace the Totally Integrated Power Module.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test