Installation

INSTALLATION

HALOGEN HEADLAMP






1. Twist lamp (1 or 2) into headlamp housing clockwise.
2. Connect the lamp electrical connector.
3. Connect the battery negative cable.

NOTE: If replacing the left low or high beam headlamp, the air box has to be reinstalled.



HIGH INTENSITY DISCHARGE (HID) HEADLAMPS (IF EQUIPPED) - LOW BEAM


HEADLAMP






1. Push the igniter straight into the headlamp unit with the connector pointing straight down. The lamp is integral to the igniter.
2. Put the retaining wire clip on the back of the lamp/igniter.




3. Connect the electrical cable connector to the lamp/igniter.




4. Install the rubber boot (1) protecting the lamp/igniter from the elements.
5. Connect the battery negative cable.

NOTE: If replacing the left low beam headlamp, the air box has to be reinstalled.

BALLAST MODULE






6. Connect the two electrical connectors (1 and 2).
- One of the connectors (1) will be a standard push tab to release connector.
- The second connector (2) has a lever that must be locked when connected.

7. Position the ballast module in of headlamp unit.




8. From the underside of the headlamp unit, install the six retaining screws (1).




9. Install the headlamp unit Front Lamp Unit - Installation.
CABLE






10. Maneuver cable through headlamp unit.




11. Connect the cable electrical connectors (2). The connector (2) has a lever that must be locked when connected.




12. From the underside of the headlamp unit, install the six retaining screws (1).




13. Connect the electrical cable connector to the lamp/igniter.




14. Install the rubber boot (1) protecting the lamp/igniter from the elements.




15. Install the headlamp unit Front Lamp Unit - Installation.